Design Guide

120
Cisco Aironet 1520, 1130, 1240 Series Wireless Mesh Access Points, Design and Deployment Guide, Release 6.0
OL-20213-01
Checking the Health of the Network
Checking the Health of the Network
Show Mesh Commands
The show mesh commands are grouped under the following headings:
• Viewing General Mesh Network Details, page 120
• Viewing Mesh Access Point Details, page 122
• Viewing Public Safety Setting, page 124
• Viewing Security Settings and Statistics, page 124
To view a summary of possible show mesh commands, enter this command:
(Cisco Controller) >show mesh ?
env Show mesh environment.
backhaul Show mesh AP backhaul info.
neigh Show AP neigh list.
path Show AP path.
astools show mesh astools list
stats Show AP stats.
secbh-stats Show Mesh AP secondary backhaul stats.
per-stats Show AP Neighbor Packet Error Rate stats.
queue-stats Show AP local queue stats.
security-stats Show AP security stats.
ap Show mesh ap summary
config Show mesh configurations.
secondary-backhaul Show mesh secondary-backhaul
ids-state Show mesh ids-state
client-access Show mesh backhaul with client access.
public-safety Show mesh public safety.
background-scanning Show mesh background-scanning state.
cac Show mesh cac.
Viewing General Mesh Network Details
• show mesh env {summary | AP_name}—Shows the temperature, heater status, and Ethernet status
for either all access points (summary) or a specific access point (AP_name). The access point name,
role (RootAP or MeshAP), and model are also shown.
– The temperature is shown in both Fahrenheit and Celsius.
– The heater status is ON or OFF.
– The Ethernet status is UP or DOWN.
Note Battery status appears as N/A (not applicable) in the show mesh env AP_name status display
because it is not provided for access points.
controller > show mesh env summary
AP Name Temperature(C/F) Heater Ethernet Battery
------------------ ---------------- ------ -------- -------
SB_RAP1 39/102 OFF UpDnNANA N/A
SB_MAP1 37/98 OFF DnDnNANA N/A