Design Guide

105
Cisco Aironet 1520, 1130, 1240 Series Wireless Mesh Access Points, Design and Deployment Guide, Release 6.0
OL-20213-01
Connecting the Cisco 1520 Series Mesh Access Point to Your Network
Using the CLI to Configure Ethernet VLAN Tagging
• To configure a MAP access port, enter this command:
config ap ethernet 1 mode access enable AP1520-MAP 50
where AP1520-MAP is the variable AP_name and 50 is the variable access_vlan ID
• To configure a RAP or MAP trunk port, enter this command:
config ap ethernet 0 mode trunk enable AP1520-MAP 60
where AP1520-MAP is the variable AP_name and 60 is the variable native_vlan ID
– To add a VLAN to the VLAN allowed list of the native VLAN, enter this command:
config ap ethernet 0 mode trunk add AP1522-MAP3 65
where AP1522-MAP 3 is the variable AP_name and 65 is the variable vlan ID
Using the CLI to View Ethernet VLAN Tagging Configuration Details
• To view VLAN configuration details for Ethernet interfaces on a specific mesh access point (AP
Name) or all mesh access points (summary), enter one of the following commands: