Design Guide

103
Cisco Aironet 1520, 1130, 1240 Series Wireless Mesh Access Points, Design and Deployment Guide, Release 6.0
OL-20213-01
Connecting the Cisco 1520 Series Mesh Access Point to Your Network
To enable VLAN tagging on a RAP or MAP using the GUI, follow these steps.
Step 1 After enabling Ethernet Bridging, click Wireless > All APs.
Step 2 Click the AP name link of the mesh access point on which you want to enable VLAN tagging.
Step 3 At the details window, select the Mesh tab. (See Figure 66.)
Figure 66 All APs > Details for (Mesh) Window
Step 4 Click the Ethernet Bridging check box to enable the feature and click Apply.
An Ethernet Bridging section appears at the bottom of the window listing each of the four Ethernet port
of the mesh access point.An Ethernet Bridging section appears at the bottom of the window listing each
of the four Ethernet port of the mesh access point.
1. If configuring a MAP access port, click gigabitEthernet1 (port 1-PoE out).
a. Select access from the mode drop-down menu. (See Figure 67.)
b. Enter a VLAN ID. The VLAN ID can be any value between 1 and 4095.
c. Click Apply.
Note VLAN ID 1 is not reserved as the default VLAN.
Note A maximum of 16 VLANs in total are supported across all of a RAP’s subordinate MAPs.