Specifications

Cisco Systems, Inc.
All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement.
Page 27 of 42
2. Click Setup and then Security. On the Security Setup page, click Authentication Server link (as shown in Figure
6-11).
Figure 6-11
Security Setup Page
3. On the “Authentication Configuration” page (see Figure 6-12):
a. Choose “DRAFT 10” for 802.1x Protocol Version.
b. Configure the AAA server (ACS server) information as follows:
i. Enter the ACS IP address.
ii. Enter 1645 or 1812 (default) for port number.
iii. Enter the shared secret between the ACS and the access point (also configured in ACS).
iv. In “Use Server for,” check EAP Authentication.