Release Notes

13
Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 4.2.176.0
OL-31336-01
Important Notes
CKIP Not Supported with Dynamic WEP
In controller software release 4.1.185.0 or later, CKIP is supported for use only with static WEP. It is not
supported for use with dynamic WEP. Therefore, a wireless client that is configured to use CKIP with
dynamic WEP is unable to associate to a wireless LAN that is configured for CKIP. Cisco recommends
that you use either dynamic WEP without CKIP (which is less secure) or WPA/WPA2 with TKIP or AES
(which are more secure).
Synchronizing the Controller and Location Appliance
For controller software release 4.2 or later, if a location appliance (release 3.1 or later) is installed on
your network, the time zone must be set on the controller to ensure proper synchronization between the
two systems. Also, Cisco highly recommends that the time be set for networks that do not have location
appliances. Refer to Chapter 4 of the Cisco Wireless LAN Controller Configuration Guide, Release 4.2
for instructions for setting the time and date on the controller.
Note The time zone can be different for the controller and the location appliance, but the time zone delta must
be configured accordingly, based on Greenwich Mean Time (GMT).
Note Daylight Savings Time (DST) is not supported in controller software release 4.2.
UNII-2 Channels Disabled on New 1000 Series Access Points for United States,
Canada, and Philippines
New Cisco 1000 series lightweight access points for the United States, Canada, and the Philippines do
not support the UNII-2 band (5.25 to 5.35 GHz). These models are labeled AP10x0-B, where “B”
represents a new regulatory domain that replaces the previous “A” domain.
FCC DFS Support on 1130 Series Access Points
Federal Communications Commission (FCC) dynamic frequency selection (DFS) is supported only on
1130 series access points in the United States, Canada, and the Philippines that have a new FCC ID.
Access points use DFS to detect radar signals such as military and weather sources and then switch
channels to avoid interfering with them. 1130 series access points with FCC DFS support have an FCC
ID LDK102054E sticker. 1130 series access points without FCC DFS support have an LDK102054 (no
E suffix) sticker. 1130 series access points that are operating in the United States, Canada, or the
Philippines; have an FCC ID E sticker; and are running the 4.1.171.0 software release or later can use
channels 100 through 140 in the UNII-2 band.