User guide

Switch2#show spanning−tree vlan 2
VLAN0002
Spanning tree enabled protocol ieee
Root ID Priority 32770
Address 0012.01c7.7c80
This bridge is the root
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID Priority 32770 (priority 32768 sys−id−ext 2)
Address 0012.01c7.7c80
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 300
Interface Role Sts Cost Prio.Nbr Type
−−−−−−−−−−−−−−−− −−−− −−− −−−−−−−−− −−−−−−−− −−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−
Gi2/0/1 Desg BKN*4 128.53 P2p *TYPE_Inc
The Smartport role Router automatically enables 802.1Q trunking on the port. If the main interface of
the remote router is used, make sure the interface of the router is part of the native VLAN of the
switch port. The interface of the router can be sub−interfaced to provide interVLAN routing for the
Cisco Catalyst Express 500 switch. See the Configure InterVLAN Routing with a Cisco Router
section of this document for configuration details.
•
You should have an additional VLAN named Cisco−Voice (case sensitive) to apply the IP
Phone+Desktop Smartport role to the ports.
•
You should have an additional VLAN named Cisco−Guest (case sensitive) to apply the Guest
Smartport role to the ports.
•
Do not apply the Other role to the ports that are connected to a sniffer or intrusion detection system
devices.
•
Apply a Smartports Role to a Single Port
Complete these steps to apply a Smartports role to a specific port:
Choose a Smartports role from the Select a port role list.1.
Click on the port. The icon for the selected Smartports role appears on the port.2.