User guide

Reset the Catalyst Express 500 Switch to Factory Default
Settings
If you have connectivity to the Device Manager of the switch and you want to reset the switch to factory
default settings and retain the current Cisco IOS system software, refer to the Reset the Switch Using the
Device Manager section of Reset the Catalyst Express 500 Series Switches to Default Factory Settings.
If you do not have connectivity to the Device Manager of the switch and you want to reset the switch to the
factory default, refer to the Reset the Switch When the Device Manager Is Not Available section of Reset the
Catalyst Express 500 Series Switches to Default Factory Settings.
Refer to the Recover the Switch Software section of User Guide for the Catalyst Express 500 Switches −
Troubleshooting for more information on the recovery procedure.
Verify
There is currently no verification procedure available for this configuration.
Troubleshoot
There is currently no specific troubleshooting information available for this configuration.
Related Information
Getting Started Guide for the Catalyst Express 500 Switches•
User Guide for the Catalyst Express 500 Switches•
Understanding EtherChannel Load Balancing and Redundancy on Catalyst Switches•
Configuring InterVLAN Routing and ISL/802.1Q Trunking on a Catalyst
2900XL/3500XL/2950 Switch Using an External Router
•
Switches Product Support•
LAN Switching Technology Support•
Technical Support & Documentation − Cisco Systems•
Contacts & Feedback | Help | Site Map
© 2009 − 2010 Cisco Systems, Inc. All rights reserved. Terms & Conditions | Privacy Statement | Cookie Policy | Trademarks of
Cisco Systems, Inc.
Updated: Jun 13, 2008 Document ID: 70485