User guide

Complete these steps to create EtherChannels between a Cisco Catalyst Express 500 and another switch:
From the Device Manager of the Cisco Catalyst Express 500 switch, select Configure >
EtherChannels to display the EtherChannels window.
1.
Click Create.2.
Enter the Channel Group ID.3.
Choose the Channel Protocol (mode) for the Mode list.
Note: The Catalyst Express 500 switch supports two modes called LACP and Static. Configure the
remote switch according to the mode you have chosen.
4.
Click on the checkboxes against the ports which should be part of the channel.5.
Click Done and click Submit to save your changes.6.
If you have chosen LACP protocol to negotiate the channel, then configure the remote switch as this
output shows:
Switch1(config)#interface gi1/0/1
7.