Specifications

Chapter 4 Configuring the Data Interfaces
Configuring the Fast Ethernet Interface
4-4
Catalyst 4224 Access Gateway Switch Software Configuration Guide
OL-2031-02
Step 2 Exit global configuration mode and attempt to reenter it using the new enable
password:
gwy1# exit
.
.
.
gwy1 con0 is now available
Press RETURN to get started.
gwy1> enable
Password: guessme
gwy1#
Tip If you are having trouble, ensure that the Caps Lock function is off; passwords are
case sensitive.
Configuring the Fast Ethernet Interface
This section describes how to configure the Fast Ethernet interface on the
Catalyst 4224.
Timesaver Before you begin, disconnect all WAN cables from the Catalyst 4224 to prevent
it from running the AutoInstall process. The Catalyst 4224 attempts to run
AutoInstall if there is a WAN connection on both ends and the Catalyst 4224 does
not have a valid configuration file stored in nonvolatile random-access memory
(NVRAM). The Catalyst 4224 can take several minutes to determine that
AutoInstall is not connected to a remote TCP/IP host.