Specifications

CHAPTER

4-1

Catalyst 4224 Access Gateway Switch Software Configuration Guide

OL-2031-02

Configuring the Data Interfaces

This section describes how to configure the data interfaces on the Catalyst 4224

To configure a data interface, you must use configuration mode. In this mode, you

enter Cisco IOS command-line interface (CLI) commands at the gateway prompt.

This section contains the following topics:

• Configuring the Host Name and Password, page 4-2

• Configuring the Fast Ethernet Interface, page 4-4

• Configuring Asynchronous/Synchronous Serial Interfaces, page 4-6

• Configuring ISDN BRI Interfaces, page 4-9

• Configuring T1 and E1 Interfaces, page 4-12

• Checking the Interface Configuration, page 4-18

• Saving Configuration Changes, page 4-19

This section describes some of the most commonly used configuration

procedures. For advanced configuration topics, refer to the Cisco IOS

configuration guide and command reference publications. These publications are

available on the Documentation CD-ROM or on Cisco.com. You can also order

printed copies separately.