Specifications

Chapter 1 Product Overview
Recommended Configurations
1-22
Catalyst 4224 Access Gateway Switch Software Configuration Guide
OL-2031-02
Interface Range Command Support
You can use the range command. The following sample configuration shows how
to configure the range command:
C4224_SF(config)# int range fas5/2 - 5
switchport access vlan 60
switchport voice vlan 160
Switched Port Analyzer (SPAN)
Switched Port Analyzer (SPAN), also known as port monitoring, is supported for
up to two sessions. Spanning a VLAN is not supported. You can only span
selected interfaces. The following sample configuration shows a configuration for
setting a port monitor session with the range command:
C4224_SF(config)# monitor session 1 ?
destination SPAN destination interface or VLAN
source SPAN source interface or VLAN
Recommended Configurations
This section contains the following topics:
• No VTP or DTP Support, page 1-23
• Creating a VLAN, page 1-23
• Defining a VLAN on a Trunk Port, page 1-23
• Trunking, page 1-24
• Fractional PRI Configuration, page 1-24
• No Ring Back Tone Generated, page 1-25
• MTP Required on Cisco CallManager, page 1-26
• H323-Gateway VOIP Bind SRCADDR Command, page 1-27
• Port Fast Not Enabled on Trunk Ports, page 1-28
• Priority Queuing on Frame Relay, page 1-28