Specifications

7-11
Catalyst 4224 Access Gateway Switch Software Configuration Guide
OL-2031-02
Chapter 7 Configuring the Eight-Port FXS RJ-21 Module
Sample Configuration
>Gateway(config-dial-peer)# dial-peer voice 2 voip
>Gateway(config-dial-peer)# destination-pattern 10
>Gateway(config-dial-peer)# session target ipv4:172.20.59.61
At this point, you should be able to send a fax or phone call from the Cisco 2600
to the FXS module, and vice versa.
Displaying Cisco 2600 Configuration Values
To display the values configured on the Cisco 2600, use the show running-config
command, as follows:
>2600# sh running-config
>Building configuration...
>
>Current configuration :951 bytes
>!
>version 12.1
>no service single-slot-reload-enable
>service timestamps debug uptime
>service timestamps log uptime
>no service password-encryption
>!
>hostname 2600
>!
>no logging buffered
>no logging buffered
>logging rate-limit console 10 except errors
>!
>ip subnet-zero
>no ip finger
>!
>frame-relay switching
>no mgcp timer receive-rtcp
>!
>interface FastEthernet0/0
> ip address 172.20.59.61 255.255.255.0
> duplex auto
> speed auto
>!
>interface FastEthernet0/1
> ip address 192.100.1.156 255.255.255.0
> shutdown
> duplex auto
> speed auto
>!