Specifications

Chapter 6 Configuring VoIP
Configure Voice Ports
6-32
Catalyst 4224 Access Gateway Switch Software Configuration Guide
OL-2031-02
Note After you change any voice port setting, Cisco recommends that you cycle the
port by using the shutdown and no shutdown commands.
Step 9
Specify the number of
seconds the system will wait
(after the caller has input the
initial digit) for the caller to
input a subsequent digit.
timeouts interdigit seconds
0 to 120 sec 10 sec
Step 10
Specify the indicated timing
parameters.
timing clear-wait milliseconds
timing delay-duration
milliseconds
timing delay-start
milliseconds
timing dial-pulse min-delay
milliseconds
timing digit
milliseconds
timing
inter-digit milliseconds
timing pulse pulses-per-second
timing
pulse-inter-digit milliseconds
timing wink-duration
milliseconds
timing wink-wait
milliseconds
200 to 2000 ms
100 to 5000 ms
20 to 2000 ms
0 to 5000 ms
50 to 100 ms
50 to 500 ms
10 to 20 pps
100 to 1000 ms
100 to 400 ms
100 to 5000 ms
Table 6-6 Commands to Fine Tune E&M Voice Ports (continued)
Task Command Valid Entries
Default
Values