Specifications

Chapter 5 Configuring the Voice Interfaces
MGCP Configuration
5-10
Catalyst 4224 Access Gateway Switch Software Configuration Guide
OL-2031-02
Step 3 Enable MGCP for the port by entering the following commands:
Gateway(config)# dial-peer voice 1 pots
Gateway(config-dial-peer)# application mgcpapp port
portnumber:ds0group
Replace portnumber with the port number on the voice gateway you are
configuring and ds0group with the DS0 group number.
Example 5-2 shows typical use of commands for configuring T-1 CAS E&M
Emulation for MGCP.
Example 5-2 T-1 CAS E&M Emulation for MGCP
Gateway(config-controller)# ds0-group 0 timeslots 1 type
e&m-wink-start
Gateway(config)# dial-peer voice 1 pots
Gateway(config-dial-peer)# application MGCPAPP
Gateway(config-dial-peer)# port 1/0:0
Configuring T1/E1 (ISDN-PRI) Ports
To configure an E1/T1 multiflex interface with ISDN-PRI signaling, use the
Cisco IOS command line interface to perform the procedures in this section.
Configuring T1 Interfaces
To configure a new T1 interface or to change the configuration of an existing
interface, perform the following procedure:
Step 1 Identify the port number and enter line-specific information provided by your
local carrier.
a. Choose the T1/PRI interface to configure:
Gateway(config)# controller t1 1/0
This example configures a T1 interface in slot 1 and unit 0.