Specifications

Chapter 5 Configuring the Voice Interfaces
MGCP Configuration
5-4
Catalyst 4224 Access Gateway Switch Software Configuration Guide
OL-2031-02
• Configuring T1-CAS E&M Emulation, page 5-8
• T1/E1 Configuration (H.323), page 5-31
• Where to Go Next, page 5-16
For more information on using MGCP with Cisco CallManager 3.0, refer to the
Cisco CallManager 3.0 online help and to Configuring Cisco IP Telephony
Gateways.
Enabling MGCP
To configure the Catalyst 4224 so that it can be controlled by
Cisco CallManager Release 3.0 using MGCP, you must identify the primary
server and any backup Cisco CallManager servers in case the primary server
becomes unavailable. You must also configure each voice gateway as an MGCP
gateway in Cisco CallManager, as described in the Cisco CallManager
Administration Guide. Finally, you must configure the voice ports installed on
your gateway.
To enable generic MGCP support on a Cisco voice gateway, enter the following
commands from the global configuration mode prompt:
Gateway(config)#mgcp
Gateway(config)#mgcp call-agent hostname
where hostname identifies the Cisco CallManager server (or possibly a generic
MGCP call agent).
To enable support for Cisco CallManager within MGCP, enter the following
command:
Gateway(config)#ccm-manager MGCP