Specifications

4-19
Catalyst 4224 Access Gateway Switch Software Configuration Guide
OL-2031-02
Chapter 4 Configuring the Data Interfaces
Saving Configuration Changes
Saving Configuration Changes
To prevent the loss of the Catalyst 4224 configuration, you need to save it to
NVRAM.
To save configuration changes, perform these steps:
Task Command
Step 1
Enter enable mode.
Enter the password.
You know you have entered enable
mode when the prompt changes to
gateway#.
gateway> enable
Password: password
gateway#
Step 2
Save the configuration changes to
NVRAM so that they are not lost
during resets, power cycles, or
power outages.
gateway# copy running-config startup-config
[or]
gateway# write memory
Step 3
Return to enable mode.
This message is normal and does
not indicate an error.
gateway(config-if)# Ctrl-z
gateway#
%SYS-5-CONFIG_I: Configured from console by
console