System information

Cisco Cat3K ST 6 June 2012
57
TOE SFRs How the SFR is Met
------- --------- ----------------- ----------------------
--------------------
20 501 isolated
20 502 community
20 503 community
20 504 non-operational
The following shows how to configure a Layer 2 interface as a PVLAN Host
Port. Beginning in privileged EXEC mode, follow these steps to configure a
Layer 2 interface as a private-VLAN host port and to associate it with primary
and secondary VLANs, note the Isolated and community VLANs are both
secondary VLANs.
Command Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2 interface interface-id Enter interface configuration
mode for the Layer 2 interface to
be configured.
Step 3
switchport mode private-
vlan
host
Configure the Layer 2 port as a
private-VLAN host port.
Step 4
switchport private-vlan
host-association
primary_vlan_id
secondary_vlan_id
Associate the Layer 2 port with a
private VLAN.
Step 5
end
Return to privileged EXEC mode.
Step 6
show interfaces
[interface-id] switchport
Verify the configuration.
Step 7
copy running-config
startup config
(Optional) Save your entries in
the switch startup configuration
file.
This example shows how to configure an interface as a private-VLAN host port,
associate it with a private-VLAN pair, and verify the configuration:
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/22
Switch(config-if)# switchport mode private-vlan host
Switch(config-if)# switchport private-vlan host-association 20 501