Installation guide

3-12

Catalyst 2960 Switch Hardware Installation Guide

OL-7075-09

Chapter 3 Switch Installation (8-Port Switches)

Installing the Switch

Figure 3-5 Installing the Mounting Screws on a Wall

Step 4

Attach the screw template to the wall.

Step 5

Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2-inch (12.7 mm) hole in the three screw

template slots.

Step 6

Insert three screws in the slots on the screw template, and tighten until they touch the top of the

screw template.

Step 7

Remove the screw template from the wall.

Step 8

Place the switch onto the mounting screws, and slide it down until it locks in place, as shown

in Figure 3-6.

1 Wall 3 Screw template

2 Screws

CABLE SIDE ENTRY

THIS SIDE AWAY FROM

MOUNTING SURFACE

157828