Installation guide

1-5
Catalyst 2960 Switch Hardware Installation Guide
OL-7075-09
Chapter 1 Product Overview
Front Panel Description
Catalyst 2960-24-S, 2960-Plus 24TC-S, 2960-24TC-S, 2960-Plus 48TC-S, 2960-48TC-S, and 2960-48TT-S
Switches
The 10/100 ports on the Catalyst 2960-24-S switch are numbered as follows: The first member of the
pair (port 1) is above the second member (port 2), port 3 is above port 4, and so on. See Figure 1-1.
Figure 1-1 Catalyst 2960-24-S Switch Front Panel
The 10/100 ports on the Catalyst 2960-Plus 24TC-S, 2960-24TC-S, 2960-Plus 48TC-S, and
2960-48TC-S switches are numbered in the same way as the Catalyst 2960-24-S switch. These switches
have dual-purpose ports, that is, 10/100/1000 ports 1 and 2 can use either the SFP module or the RJ-45
connector for that port, but not both at the same time. Use the software to set the connector type for these
ports. For more information about the dual-purpose port, see the “Dual-Purpose Port” section on
page 1-13. See Figure 1-2 and Figure 1-3.
Figure 1-2 Catalyst 2960-Plus 24TC-S and 2960-24TC-S Switch Front Panel
Figure 1-3 Catalyst 2960-Plus 48TC-S and 2960-48TC-S Switch Front Panel
1 10/100 ports
Catalyst 2960
Series SI
SYST
STAT
DUPLX
SPEED
MODE
1
204632
1 10/100 ports 2 Dual-purpose ports
Catalyst 2960
Series SI
SYST
STAT
DUPLX
SPEED
MODE
204631
2
1
1 10/100 ports 2 Dual-purpose ports
Catalyst 2960
Series SI
SYST
STAT
DUPLX
SPEED
MODE
1 2
204630
65 87 109 1211 21 43
1817 2019 2221 1413 1615
3029 3231 3433 3635 2625 2827
4241 4443 4645 4847 3837 4039
2423