Datasheet

Page 8 of 2878-19803-02 Cisco TelePresence System T3 System Assembly Guide, December 2011
10.Unpack the next bottom module. Unscrew the top
screw and the cable hatch cover on both sides of the
module.
11. Mount the center bottom module onto the floor
structure.
12.Insert the center DNAM cable 117852 and attach it
to the center DNAM module in a way similar to what
was done to the right bottom module, This must be
done before the monitor is mounted onto the bottom
module. Once the monitor is mounted, cable insertion
will become very difficult.
The DNAM cable 117852 is located in the accessories
kit.
13.Unpack the next monitor assembly and remove the top
side screw on both sides of the monitor.
14.Mount the center monitor onto the center bottom
module.
15.Unpack the third bottom module. Unscrew the top
screw and the cable hatch cover on the right side of the
module.
16.Mount the left bottom module onto the floor structure.
17. Insert the left DNAM cable 117850 and attach it to the
left DNAM module in a way similar to what was done
to the center and right bottom modules, This must be
done before the monitor is mounted onto the bottom
module. Once the monitor is mounted, cable insertion
will become very difficult.
The DNAM cable 117850 is located in the Accessories
kit.
18.Unpack the final monitor assembly and remove the top
side screw on right side of the monitor.
19. Mount the left monitor onto the left bottom module.