Datasheet

Page 14 of 2878-19803-02 Cisco TelePresence System T3 System Assembly Guide, December 2011
Note!The splitter cable for the TCU found in the kit must be
put aside for later use. See “Details of cable bundling kits
17–21” on page 13 for more when and where to use it.
5. Unscrew the nuts holding the bracket in the right column.
Turn on the Presentation input switch and the Splitter
power switch before mounting. Fasten switch and
splitter in the same manner as the TCU was fastened.
Note the orientation of both units (shown below) Fasten
the two power supplies as shown below.
Splitter
Switch
The power
supplies for
Splitter and Switch
goes here
System connections
To connect the different parts of the system, a set of ready-
to-use cable bundling kits come with the system. The
following pages outline where to put each cable kit.
Details on the connections are found in the Cabling
Schematics drawing, which is located in the Cable
Bundling kit box.
Use the information on the following pages in combination
with the Cable Schematics drawing to insert, attach and
connect all cables correctly.
Note! Some cables come with a color coding. For these
cables blue is system end and red is table end.
Note! Cable clamps inside bottom modules should be put
back in place once all cabling has been completed.