Datasheet

Page 13 of 2878-19803-02 Cisco TelePresence System T3 System Assembly Guide, December 2011
TCU, Splitter and Switch
Doasfollows:
1. The Telepresence Control Unit (TCU) is to be inserted
in the left table column. Unscrew the nut holding the
bracket (outer bracket shown in green in the below Fig.)
in the left column.
The TCU runs off line voltage directly and needs no
further external power supply.
2. Find the TCU in the box marked “T3 Telepresence kit”
and fasten the TCU to the left column, using the bracket
and the same nut as were just loosened.
3. Now, loosen the two nuts shown.
4. Install the power distribution block, put the nuts back
and fasten them.