Datasheet

Page 10 of 2878-19803-02 Cisco TelePresence System T3 System Assembly Guide, December 2011
Table Top Module
Carefully unpack the box labeled “T3 Table Top”, where you
will find the left-, center- and right table top assemblies.
Table top
tighteners
Right table top
assembly
Center table top
assembly
Left table top
assembly
You will also need the table top tighteners (left). There are
four altogether. These are located in the kit of screws.
Doasfollows:
1. Slide the center table top assembly into both columns.
2. Fasten two nuts (M8) and one screw M8×16 in each
joint of the table tops. Start by fastening the nuts
pointing towards the system (1 & 2). Then fasten the
other screws (3). Screw finger tight only.
1
2
3
3. When assembling the table, you will need the 120774
Lamells and the table top tighteners, as shown.
4. Tilt the center table top assembly (1) by lifting the
“chair-side” of it slightly (<5°) and slide the right table
(2) top so that the steel profile holds them together.
1
2
3
5. Repeat for the other table top module (3).
6. Adjust the table modules slightly, if needed, to obtain
the best fit, then apply the four table top tighteners, as
shown.
7.  Fasten using 16 pcs M6 nut and 4 pcs M8×16 screws,
as indicated by the circles below. Tighten all screws
and nuts.
Left Right
System
Table
Overview