Datasheet

AC Input 1 AC Input 2
Net Power Supply
Output
110Vac, 16A Not Connected No Power Output
Not Connected 110Vac, 16A No Power Output
110Vac, 16A 110Vac, 16A 2900W
220Vac, 16A Not Connected 2900W
Not Connected 220Vac, 16A 2900W
110Vac, 16A 220Vac, 16A 2900W
220Vac, 16A 110Vac, 16A 2900W
220Vac, 16A 220Vac, 16A 6000W
Note: If you have 110Vac power inputs, you have to connect both the AC inputs of the 6000W
power supply in order to power on the switch.
● The Catalyst 6500 series switches allow you to mix AC-input and DC-input power supplies in the
same chassis.
The modules have different power requirements, and some configurations require more power than a single
power supply can provide. The power management feature allows you to power all installed modules with
two power supplies. But, redundancy is not supported in this configuration because the total power drawn
from both power supplies is at no time greater than the capability of one supply. Refer the
Power
Management and Environmental Monitoring of the Catalyst 6500 Software Configuration Guide for the
detailed explanation of Power redundancy.
Note: This document does not discuss the total power available with the currently shipped power supplies
for Catalyst 6500/6000 series switches or the amount drawn from each Catalyst 6500/6000 series line card.
Refer to the document Power Management for Catalyst 6000 Series Switches for this information.
Catalyst 6500/6000
Power
Supply
Part
Number
Power
Cord
Part
Number
Connector Type
Power
Installation
Guidelines