Datasheet

WS-X5114

WS-X5201

WS-

X5201R 12

100Base-

FX ports

SC fiber-optic

(for 100Base-

FX)

SMF/MMF

fiber-optic

WS-X5403

3 port

GBIC

modules

slots

WS-X5410

9 GBIC

module

slots

SC fiber-optic

(for

1000BaseSX/

LX/ZX

GBICs)

SMF/MMF

fiber-optic

Category 3 UTP cable can transmit data at speeds of up to 10 Mbps and therefore is only used for 10

Mbps network devices. Catalyst 5000 10Base-T telco switching modules can use Category 3 cable, but

Category 5 cable is required for all other 10/100 Base-TX switching modules.

LX/LH GBICs require a mode-conditioning patch cord between the GBIC and MMF. Refer to the Mode-

Conditioning Patch Cord section of the document Connector and Cable Specifications for more

information.

Catalyst 4500/4000 Switch Connectors and Cables

Refer to Catalyst 4500 Series Module Installation Guide - Module Overview and Specifications for the

detailed specification for the Catalyst 4500 switching modules.

Refer to Catalyst 4000 Switching Modules for the detailed specification for the Catalyst 4000 switching

modules.

Catalyst 3750 Connectors and Cables

Identify the switch chassis part number. Use this table in order to match up the part number with the type

of connector and cable used.

Note: The Catalyst 3750 switch ships with a 0.5-meter StackWise cable that you can use in order to

connect the StackWise ports on the rear panel. You can also order these StackWise cables from your Cisco