Troubleshooting guide

13-33
ATM and Layer 3 Switch Router Troubleshooting Guide
OL-1969-01
Chapter 13 Troubleshooting ATM Router Module Connections
Troubleshooting Frame Relay PVC, Terminating on ATM Router Module
Wrr weight: 2
Cross-connect-interface: ATM10/0/1, Type: arm_port
Cross-connect-VPI = 2
Cross-connect-VCI = 50
Threshold Group: 5, Cells queued: 0
Rx cells: 0, Tx cells: 0
Tx Clp0:0, Tx Clp1: 0
Rx Clp0:0, Rx Clp1: 0
Rx Upc Violations:0, Rx cell drops:0
Rx pkts:0, Rx pkt drops:0
Rx connection-traffic-table-index: 110
Rx service-category: UBR (Unspecified Bit Rate)
Step 3 Verify the Status is up.
Step 4 Verify that the Cross-connect-interface is the ATM router module internal interface.
Troubleshooting Frame Relay PVC, Terminating on ATM Router
Module
This section describes troubleshooting Frame Relay PVCs that terminate on the ATM router module.
To display the ATM router module and Frame Relay PVC configuration, use the following commands:
Note In the following examples the ATM router module is installed in slot 4.
Command Purpose
show running-config Shows the status of the configuration and
physical interfaces.
show interfaces serial card/subcard/port:cgn Shows Frame Relay configuration and
status.
show atm vc interface atm card/subcard/port
[vpi vci]
Shows the PVCs configured on the ATM
router module interface.
show controllers {atm | e1 | t1}
card/subcard/port:cgn
Shows information about a physical port
device.
show atm traffic Shows the ATM layer traffic information
for all of the ATM interfaces.