Troubleshooting guide

ManualsBrandsCisco ManualsComputer equipmentC8510-SRP - Switch Route Processor

421

422

423

424

425

426

427

428

429

430

13-19

ATM and Layer 3 Switch Router Troubleshooting Guide

OL-1969-01

Chapter 13 Troubleshooting ATM Router Module Connections

Troubleshooting LANE Clients on ATM Router Module Connections

The following are the routing and node tables created for the network configuration on the Catalyst 8540

with an ATM router module shown in Figure 13-8.

Routing Table

Network 100, Primary network, FastEth 1/0/0

Network 200, Primary network, ATM 3/0/0.1

Node Table:

FastEth 1/0/0 100.00ab.cdef.0001 Interface no.

ATM 3/0/0.1 200.00ab.cdef.0002 Data VC

Troubleshooting IP switching with the ATM router module configured between the ATM and Ethernet

interfaces is essentially the same as described in the “Troubleshooting IPX Layer 3 Routing” section on

page 11-38. However, you must confirm connections and adjacencies through the ATM router module.

General ATM Router Module Troubleshooting

Use the following commands to troubleshoot general ATM router module connections:

Use the following commands to troubleshoot the ATM router module LECs and the configuration:

Step 1 Use the ping command to confirm the LEC connection to the end station.

Switch# ping 128.250.20.1

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 128.250.20.1, timeout is 2 seconds:

3d09h: LEC ATM10/0/0.3: received SETUP

3d09h: LEC ATM10/0/0.3: callid 0x638CACB8

3d09h: LEC ATM10/0/0.3: called party 39.036F10070306000101000000.009021418817.03

3d09h: LEC ATM10/0/0.3: calling_party 39.036F100703060010073C1501.0010F66C841C.03

3d09h: LEC ATM10/0/0.3: sending CONNECT

3d09h: LEC ATM10/0/0.3: callid 0x638CACB8

3d09h: LEC ATM10/0/0.3: vcd 943

3d09h: LSSLEC:LANE-Cache_VC:if=45 vc=943 type=6

3d09h: LEC ATM10/0/0.3: received CONNECT_ACK.!!.!

Success rate is 60 percent (3/5), round-trip min/avg/max = 1/1/1 ms

3d09h: LSSLEC:ADJ:Host:128.250.20.1 MAC:0000.0c07.ac03 Valid:TRUE MyIP:FALSE if=8 vc=943 if_vc=45

Check the if_vc= field and make note of the interface VC number. In this case, the interface VC is “45.”

Command Purpose

ping ip-address Tests the network node reachability.

show epc ifmapping interface-map-number Displays interface mapping to CAM

interface number.

show epc ip-address interface atm

card/subcard/port ip-address

Displays all adjacent IP addresses for the

specified interface.