Troubleshooting guide

13-10
ATM and Layer 3 Switch Router Troubleshooting Guide
OL-1969-01
Chapter 13 Troubleshooting ATM Router Module Connections
Hardware and Software Restrictions of the ATM Router Module
Troubleshooting the ATM Router Module Hardware
The ATM router module for the Catalyst 8510 MSR is based on the single-port Gigabit Ethernet
interface module. The ATM router module for the Catalyst 8540 CSR is based on the dual-port Gigabit
Ethernet interface module. The ATM router module does not have the fiber transceivers in the faceplate.
The Gigabit Ethernet processor interfaces are terminated on the board and only connect to the other
interfaces on the ATM switch router through the backplane.
Note You can access the ATM router module interfaces using the standard CLI show interface atm
card/subcard/port command and other interface commands.
On the faceplate, there is only one Status LED. If that LED appears green, the ATM router module is
functioning properly, red means the ATM router module has failed its internal diagnostic self-tests.
Follow these steps to troubleshoot the ATM router module hardware:
Step 1 Use the show hardware detail command to confirm the ATM router module FPGA version and CAM
configuration.
Switch# show hardware detail
Switch named Switch, Date: 18:23:14 UTC Tue Dec 5 2000
Slot Ctrlr-Type Part No. Rev Ser No Mfg Date RMA No. Hw Vrs Tst EEP
---- ------------ ---------- -- -------- --------- -------- ------- --- ---
0/* Super Cam 73-2739-03 D0 03170TAL May 03 99 0 3.1
0/0 8T1 IMA PAM 73-3367-02 B2 03100061 Mar 15 99 00-00-00 2.0 0 0
0/1 8E1 IMA PAM 73-3378-02 B2 03120056 Mar 25 99 00-00-00 2.0 0 2
2/* ARM PAM 73-4208-01 05 03150016 Apr 18 99 1.0
3/* ETHERNET PAM 73-3754-06 B0 03282WBF Jul 13 99 0 5.1
9/* OC48c PAM 73-3745-02 12 03190UXC Jun 28 99 2.1
10/* OCM Board 73-4165-01 04 03230ZZ2 Jun 28 99 10.1
10/0 QUAD 622 Gen 73-2851-05 A0 03160RVS Jun 16 99 5.0
11/* OC48c PAM 73-3745-02 12 03100015 Jun 28 99 2.1
12/* OCM Board 73-4165-01 04 03190UJV Jun 28 99 10.1
12/0 QUAD 622 Gen 73-2851-05 A0 03160S9J Jun 16 99 0 5.0
.
(Information Deleted)
.
slot: 2/* Controller-Type : ARM PAM
Part Number: 73-4208-01 Revision: 05
Serial Number: SCA03150016 Mfg Date: Apr 18 99
RMA Number: H/W Version: 1.0
FPGA Version: 2.3
EPIF Version: 1704 CAM size: 64 KB
Ucode Version: 0.0 CAM Type: Dual
Port Phy Setup
Port 0: DONE GBIC Vendor: No vendor info.
Port 1: DONE GBIC Vendor: No vendor info.
slot: 3/*
.
(Information Deleted)
.