Troubleshooting guide

ManualsBrandsCisco ManualsComputer equipmentC8510-SRP - Switch Route Processor

151

152

153

154

155

156

157

158

159

160

6-19

ATM and Layer 3 Switch Router Troubleshooting Guide

OL-1969-01

Chapter 6 Troubleshooting Switch Router ATM Network Connections

Troubleshooting SVC Connections on a PNNI Routing Network

Follow these steps to confirm that the originating end of the SVC connection (RemDvLs1 ATM 3/1/1 in

this example) has the correct interface status, type, and UNI version compatible with the end system:

Step 1 Use the show atm interface command on the RemDvLs1 ATM 3/1/1 in this example.

RemDvLs1# show atm interface atm 3/1/1

Interface: ATM3/1/1 Port-type: oc3suni

IF Status: UP Admin Status: up

Auto-config: enabled AutoCfgState: completed

IF-Side: Network IF-type: UNI

Uni-type: Private Uni-version: V3.1

Max-VPI-bits: 2 Max-VCI-bits: 10

Max-VP: 255 Max-VC: 16383

ConfMaxSvpcVpi: 255 CurrMaxSvpcVpi: 3

ConfMaxSvccVpi: 255 CurrMaxSvccVpi: 3

ConfMinSvccVci: 33 CurrMinSvccVci: 33

Svc Upc Intent: pass signalling: Enabled

ATM Address for Soft VC: 47.0091.8100.0000.00e0.4fac.b401.4000.0c85.0000.00

Configured virtual links:

PVCLs SoftVCLs SVCLs TVCLs PVPLs SoftVPLs SVPLs Total-Cfgd Inst-Conns 2

0 0 0 0 0 0 2 2

Logical ports(VP-tunnels): 0

Input cells: 113971 Output cells: 98053

5 minute input rate: 2000 bits/sec, 4 cells/sec

5 minute output rate: 2000 bits/sec, 4 cells/sec

Input AAL5 pkts: 64732, Output AAL5 pkts: 80752, AAL5 crc errors: 0

EngFl1Ls1#

Step 2 Check to see whether the IF Status is UP. If it is not, see Chapter 5, “Troubleshooting Switch Router

ATM Interface Connections.”

Step 3 Check to see whether the IF-type is UNI. If it is not, see the “Configuring Interfaces” chapter in the ATM

Switch Router Software Configuration Guide.

Step 4 Check to see whether the UNI-version is compatible at both end systems. If it is not, see the “Configuring

Interfaces” chapter in the ATM Switch Router Software Configuration Guide.

Step 5 Next use the show atm interface command to confirm the EngFl1Ls1 ATM0/0/0 in this example:

EngFl1Ls1# show atm interface atm 0/0/0

Interface: ATM0/0/0 Port-type: oc3suni