Specifications

Samsung Electronics
Service Manual
Disassembly and Reassembly
5-34
1. Before you remove the Exit Roller, you should
remove:
- Fuser Drive Ass'y (Refer to 5.16)
- Middle Cover Ass'y (Refer to 5.21)
2. Remove the Exit Gear, and release the Bearing at
one end then remove the Roller Exit F/Down and Exit
Roller Rack, as shown below.
Notice : Do not grab the rubber part of the Feed1 Roller,
it may cause a malfunction due to a foreigen
object.
5.26 Exit Roller
1
2
1
Exit Gear
Roller Exit F/Down
Exit Roller Rack
Bearing
1. Before you remove the Pick Up Gear Ass'y &
Solenoids, you should remove:
- Duplex Guide Housing (Refer to 5.19)
- Feed Bracket Unit (Refer to 5.24.5)
2. Release the Pick Up Gear Ass'y and Pick Up Gear
Shaft, as shown below.
3. Remove the two screws securing the Manual
Solenoid and Feed Solenoid and then remove the
Solenoids, as shown below.
Feed Solenoid
Manual Solenoid
Pick Up Gear Ass’y
Pick Up Gear Shaft
5.25 Pick Up Gear Ass'y & Solenoids