Specifications

24-3
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Chapter 24 Configuring BXM Virtual Circuits
BXM Commands
Note You can configure the range of VPIs and VCIs reserved for PVC traffic and SVC traffic
by using the cnfport command. While adding connections, the system checks the entered
VPI/VPC against the range reserved for SVC traffic. If there is a conflict, the addcon
command fails with the message “VPI/VCI on selected port is reserved at local/remote
end”.
BXM Commands
This section provides a preliminary summary of configuration, provisioning, and monitoring
commands associated with the BXM cards. These commands apply to initial card configuration, line
and trunk configuration and provisioning, and connection configuration and provisioning.
Connection Provisioning
• addcon
Add connection
• cnfcon
Configure connection
• dspcon
Display connection
Diagnostics
• addlnloclp
Add local loopback to line
• addlnlocrmtlp
Add local remote loopback to line
• dellnlp
Delete local or remote loopback
Test
• tstconseg
Test connection externally with OAM segment loopback cells
• tstdelay
Test connection round trip delay
Statistics
• Line and Trunk statistics
– cnflnstats
Configure line statistics collection
– dsplnstatcnf
Display statistics enabled for a line
– dsplnstathist
Display statistics data for a line
– cnftrkstats
Configure trunk statistics collection
– dsptrkstatcnf
Display statistics enabled for a trunk