Manualshelf

Specifications

ManualsBrandsCisco ManualsComputer equipmentBPX-BXM-622-2DX
31323334353637383940
Figures
xxix
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Figure 10-2 DC Power Connections—With Conduit Box 10-3
Figure 10-3 DC Power Connections—Without Conduit Box 10-4
Figure 11-1 Temporary Spacer Bracket and Support Bracket Installation 11-2
Figure 11-2 Power Supply Tray aligned with Temporary Support Brackets and Bar 11-3
Figure 11-3 Removing an Air Intake Grille 11-4
Figure 11-4 Securing AC Power Supply Tray, 30-Inch Rail Setback 11-5
Figure 11-5 Securing an AC Power Supply Tray, 19.86 inch Rear Rail Setback 11-6
Figure 11-6 AC Power Supply Tray with Redundant AC Inputs (view from rear) 11-7
Figure 11-7 Removing an Air Intake Grille 11-8
Figure 11-8 AC Power Supply Installation 11-9
Figure 11-9 AC Power Supply Connections (Dual and Single Versions Shown) 11-11
Figure 11-10 AC Power 11-12
Figure 12-1 Installation of Cable Management Tray Brackets 12-2
Figure 12-2 Sliding Cable Management Tray over Brackets 12-3
Figure 12-3 Cable Management Tray in Lowered Home Position 12-3
Figure 12-4 Cable Management Tray in Raised Position 12-4
Figure 12-5 Installing BXM T3/E3 Cable Bracket 12-5
Figure 12-6 Connecting Cables to T3/E3 Card 12-6
Figure 12-7 T3/E3 SMB Connector Detail 12-6
Figure 12-8 Cables Routed through Cable Management Tray in Lowered Position 12-7
Figure 12-9 Tray Raised with Cables in Place 12-8
Figure 13-1 BPX Shelf (front view) 13-3
Figure 13-2 BPX Shelf (rear view, DC shelf shown) 13-3
Figure 13-3 Removing an Air Intake Grille 13-5
Figure 13-4 Laser Information Label 13-6
Figure 13-5 Installing a Back Card 13-7
Figure 13-6 Card slot and fan fuses, identifying the 19.2 Gpbs backplane 13-8
Figure 13-7 Y-Cable Connection 13-11
Figure 13-8 Y-Cables on Multiple Ports 13-11
Figure 13-9 APS 1:1 Redundancy 13-13
Figure 13-10 APS 1+1 Redundancy 13-13
Figure 13-11 APS Redundant Frame Assembly 13-14
Figure 13-12 BPX Shelf, Rear View 13-15
Figure 13-13 Installing APS Redundant Frame Assembly and Backcards into Place 13-16
Figure 14-1 Connecting T3 Cables to BPX LM-T3 (BNI T3 backcard) 14-3