Specifications

19-4
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Chapter 19 Configuring Circuit Lines
Setting Up a Circuit Line
Figure 19-3 Setting Up Frame Relay Lines
Figure 19-4 Setting Up ATM Lines
Line Commands
Table 19-3 Here are the names and descriptions for each line command:
SETUP FRAME
RELAY LINES
AND PORTS?
Multiplex?
Configure
connections
UPFRPORT
CNFFRPORT
UPCLN CNFCLN ADDFRPORT
Other?
Yes
No
Yes
No
VT
S5305
SETUP ATM LINES
AND PORTS?
Configure
connections
UPLN CNFLN ADDPORT UPPORT CNFPORT
Other
side?
Ye s
No
VT
S5306
Table 19-3 Line Commands
Name Description
cnfcassw Configure CAS switching
cnfln Configure line (same as cnfcln)
cnfrsrc Configure resources
dnln Down line (same as dncln). A downed line is inactive, so no signals or
statistics are generated. You must remove all connections on a line (delcon
or delcongrp) before you down the line by uising dnln.
dsplncnf Display line configuration (same as dspclncnf). Displays the configuration
of a specified circuit line.
dsplns Displays the circuit line configuration and alarm status for the node (same
as dspclns)
dsptsmap Display time slot map
prtlns Prints the circuit line configuration and circuit line alarm status for the
node (same as prtclns)
upln Up line (same as upcln)