Specifications

17-4
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Chapter 17 Initial BPX 8600 Node Configuration
Command Sequences for Setting Up Nodes
The “dspnode” screen displayed at the “shlf3igx” node shows that it is connected to the BPX switch
via AIT trunk 8.
shlf3IGX TN edgar IGX 8 9.3 June 20 2000 09:24 PDT
BPX Switching Shelf Information
Trunk Name Type Alarm
8 hubone BPX MAJ
Last Command: dspnode
Next Command:
Command Sequences for Setting Up Nodes
Follow the illustrated command sequences to perform these node-related tasks:
• Set up a node. See in Figure 17-1
• View information about the presence of the cards and system power. See Figure 17-2.
• Configure an interface for a control terminal that is connected to the node. See Figure 17-3.
• Remove a node from a network. See Figure 17-4.
• Add an interface shelf. See Figure 17-5.
Figure 17-1 Setting Up Nodes
Figure 17-2 Viewing the Node Configuration
Log on to
a node
Local or
remote?
View node
configuration
CNFNAME CNFTMZN ADDYRED DSPYRED ADDALMSLOT
Another
node?
Local
Remote
Ye s
No
VT
S5323
Log on to
a node
Local or
remote?
Configure
attached devices
DSPCDS DSPCD DSPPWR
Another
node?
Local
Remote
Yes
No
VT
S5298