Specifications

15-9
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Chapter 15 Connecting Temporary Terminal and Attaching Peripherals
Connecting a Network Printer to the BPX Switch
Step 3 For nodes with redundant BCCs: A Y-cable is required for this application.
Connect one leg of the Y-cable to the AUXILIARY port connector on the LM-BCC in slot 7.
Connect the other leg to the AUXILIARY port connector on the LM-BCC in slot 8.
Step 4 Plug the printer power cord into the appropriate AC outlet (115 VAC or 240 VAC).
Step 5 Set the port function for printer by using the cnftermfunc command.
Step 6 Make sure the control port and the printer are set to the same baud rate and check the other
communication parameters by using the cnfterm command.
Figure 15-3 Connections to a Network Printer, LM-BCC Shown
Auxiliary
port
(DB25)
RS-232
Network
printer
Maint.
log
H8014
L
A
N
C
O
N
T
R
O
L
A
U
X
I
L
I
A
R
Y
X
F
E
R
T
M
G
E
X
T
T
M
G
E
X
T
T
M
G
LM-BCC
Slot #7
LM-
BCC