Specifications

12-7
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Chapter 12 Installing the T3/E3 Cable Management Tray
Routing Cables from Cards through Cable Management Tray
Routing Cables from Cards through Cable Management Tray
To route cables as shown in Figure 12-8:
Step 1 Verify that the cable management tray is in the lowered home position.
Step 2 Route cables from the cards through the cable clamps on the cable management tray.
Step 3 Secure the cable management tray to the cable tray brackets by inserting and tightening securing screw,
onetoeachbracket.
Figure 12-8 Cables Routed through Cable Management Tray in Lowered Position
Tray Raised with Cables in Place
Figure 12-9 shows how to raise the cable management tray with cables in place, to provide access to
the Power Entry Modules (PEMs).
10013
To customer-supplied
interface panel
Cable clamp
Securing screw
(one each side)