Specifications

12-4
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Chapter 12 Installing the T3/E3 Cable Management Tray
Installing BXM T3/E3 Cable Bracket
To raise the tray to provide access to the PEMs:
Step 1 Remove the securing screws as necessary.
Step 2 With two hands, pull the tray towards youself and up.
Step 3 Raise the tray to the upper position and lower it onto the upper slots.
Figure 12-4 Cable Management Tray in Raised Position
Installing BXM T3/E3 Cable Bracket
To attach the BXM T3/E3 cable bracket to each BXM T3/E3 card as shown in Figure 12-5:
Step 1 Remove the bracket from the kit.
Step 2 Place the bracket in position as shown.
Step 3 Screw in and tighten the captive screw.
Step 4 Insert one end of the cable tie through the hole in the bracket.
H10009