Specifications

11-9
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Chapter 11 Installing the AC Shelf
Installing an AC Power Supply
Figure 11-8 AC Power Supply Installation
Step 7
Align the power supply in the PS-A slots at the bottom of the Power Supply Tray and gently slide it in
part way (see Figure 11-8).
Step 8 Continue to slide the power supply in until it mates with the rear connector.
Step 9 When the power supply is completely seated in its connector, the pin plunger on the left side of the
supply will engage with a hole in the tray. If not, push firmly on the front edge until the power supply
assembly seats in the connector.
Step 10 Screw the right-hand thumbscrew in finger tight.
Step 11 When a second power supply is provided, install it in the PS-B slot in the same manner after removing
the Blank Panel from Slot B.
Step 12 Rotate the power supply retainer up and tighten the center captive screw.
Step 13 Install the Air Intake Grille. Press on the top center until the latch snaps into place.
SLOT A
SLOT B
Power supply
thumb screw
Power supply
retainer
Retainer
captive
screw
H8212
Slot B empty if
non-redundant
Power
supply
Power supply
plunger hole
Plunger
Power supply
thumb screw