Specifications

8-9
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Chapter 8 Installation with Cisco Cabinets including 7000 Series Routers
Installing a 7200 or 7500 Router in a BPX 8650 Cabinet or Rack
Step 7 If this is an AC-powered shelf, proceed to Chapter 11, Installing the AC Shelf.
Figure 8-8 Installing the Router Enclosure Assembly in a 19-inch Open Rack
Installing Router Assembly in a 23-Inch Open Rack
Install the router enclosure assembly in BPX 8650 cabinet (see Figure 8-9):
Step 1 Slide the router enclosure assembly into the cabinet on top of the BPX shelf.
Step 2 Attach the two support brackets (for 23-inch open rack mounting) from the hardware kit, one to each
side of the router enclosure assembly, using five securing screws for each bracket.
Step 3 Slide the router enclosure assembly into the cabinet on top of the BPX shelf.
Step 4 Secure the the front of router assembly to the rack with three screws on each side.
Step 5 Connect the power cord to the router connectorreceptacle at the front of the cabinet, and close the router
enclosure assembly door.
Step 6 Use the tie wraps provided in the hardware kit to secure the power cord to a Cable Management Bracket.
Step 7 If this is a DC-powered shelf, proceed to Chapter 10, Installing the DC Shelf.
Step 8 If this is an AC-powered shelf, proceed to Chapter 11, Installing the AC Shelf.
18950
Label Switch Controler
CISCO BPX 8600
SERIES
WIDE AREA SWITCH
19 in. open rack
Cable management bracket