Specifications

8-8
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Chapter 8 Installation with Cisco Cabinets including 7000Series Routers
Installing a 7200 or 7500 Router in a BPX 8650 Cabinet or Rack
Step 8 If this is an AC-powered shelf, proceed to Chapter 11, Installing the AC Shelf.
Figure 8-7 Installing the Router Enclosure Assembly in the Cisco BPX 7650 Cabinet
Installing Router Assembly in a 19-Inch Open Rack
Install the router enclosure assembly in BPX 8650 cabinet (see Figure 8-8):
Step 1 Slide the router enclosure assembly into the cabinet on top of the BPX shelf.
Step 2 Attach the two support brackets (for 19-inch open rack mounting) from the hardware kit, one to each
side of the router enclosure assembly, using two securing screws for each bracket.
Step 3 Secure the front of the router assembly to rack with two screws on each side.
Step 4 Connect the power cord to the router connectorreceptacle at the front of the cabinet, and close the router
enclosure assembly door.
Step 5 Use the tie wraps provided in the hardware kit to secure power cord to a Cable Management Bracket.
Step 6 If this is a DC-powered shelf, proceed to Chapter 10, Installing the DC Shelf.
Label Switch Controler
CISCO BPX 8600
SERIES
WIDE AREA SWITCH
19 in. cabinet
Support bracket
with lip
18722
Cable management bracket