Specifications

5-10
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Chapter 5 BXM Card Sets: T3/E3, 155, and 622
BXM Front Card Indicators
Types of failures are indicated by various combinations of the card status indicators as described in
Table 5-6.
Table 5-5 BXM Front Panel Status Indicators
Status LED color Status Description
port off Trunk/line is inactive and not carrying data.
green Trunk/line is actively carrying data.
yellow Trunk/line is in remote alarm.
red Trunk/line is in local alarm.
card green (act) Card is on-line and one or more trunks/lines on the card have been
upped. If off, card may be operational but is not carrying traffic.
yellow (stby) Card is off-line and in standby mode (for redundant card pairs).
May not have any upped trunks/lines. If blinking, indicates card
firmware or configuration data is being updated.
red (fail) Card failure; card has failed self-test and/or is in a reset mode.
Table 5-6 BXM Front Panel Card Failure Indicators
act stby fail Failure Description
on off on Non-fatal error detected; card is still active.
off on on Non-fatal error detected; card is in standby mode.
off blinking on Fatal error detected; card is in a reboot mode.
on on on Card failed boot load and operation is halted.