Installation guide

8-6
Cisco 10000 Series Routers Line Card Hardware Installation Guide
OL-6773-04
Chapter 8 6-Port Channelized T3 Line Card Overview
Cables and Connectors
Figure 8-3 Line Card Slot Designations for the Cisco 10005 Router
The 6-port channelized T3 line card can be installed in line card slot 1 through slot 5.
Cables and Connectors
External network connections to the 6-port channelized T3 line card are made through the BNC
connectors mounted on the rear of the Cisco 10000 chassis, using 75-ohm coaxial cable. The approved
cables for use with the 6-port channelized T3 line card are cables conforming to WECO standards 728A,
734A, or 734D. Use cable lengths up to 900 ft (274.32 m). 735A cables can be used with lengths up to 225 ft
(68.58 m).
See Figure 8-4 for the BNC connectors on the rear of the Cisco 10008 router, and Figure 8-5 for the
BNC connectors on the rear of the Cisco 10005 router.
1 PRE slot A 3 Line card slots 1 (top) to 5 (bottom)
2 PRE slot B
132516
CISCO
10000
PERFORMANCE ROUTING ENGINE
FAIL
STATUS
ACO
CRITICAL
MINOR
MAJOR
CONSOLE
ETHERNET
LINK
ACTIVITY
AUX
SLOT 0
SLOT 1
CISCO
10000
PERFORMANCE ROUTING ENGINE
FAIL
STATUS
ACO
CRITICAL
MINOR
MAJOR
CONSOLE
ETHERNET
LINK
ACTIVITY
AUX
SLOT 0
SLOT 1
CISCO
10000
ENABLE
ALARM
LOOP
FAIL
OC-12/STM-4 ATM SM-IR
CARRIER
TX
RX
CISCO
10000
CARRIER
ALARM
LOOP
FAIL
6XCT3–DS0
0
1
2
3
4
5
CISCO
10000
CARRIER
ALARM
LOOP
FAIL
6XCT3–DS0
0
1
2
3
4
5
CISCO
10000
CARRIER
TX
RX
FAIL
OC-12/STM-4 POS SM-IR
CISCO
10000
CARRIER
TX
RX
FAIL
OC-12/STM-4 POS SM-IR
3
1
2