Installation guide

2-6
Cisco 10000 Series Routers Line Card Hardware Installation Guide
OL-6773-04
Chapter 2 8-Port E3/DS3 ATM Line Card Overview
Cables and Connectors
Figure 2-3 Line Card Slot Designations for the Cisco 10005 Router
The 8-port E3/DS3 ATM line card can be installed in slot 1 through slot 5.
Cables and Connectors
External network connections to the 8-port E3/DS3 ATM line card are made through the BNC connectors
mounted on the rear of the Cisco 10000 chassis, using 75-ohm coaxial cable. The approved cables for use
with the 8-port E3/DS3 ATM line card are cables conforming to WECO standards 728A, 734A, or 734D.
Use cable lengths up to 450 ft (137.16 m). 735A cables can be used with lengths up to 225 ft (68.58 m).
1 PRE slot A 3 Line card slots 1 (top) to 5 (bottom)
2 PRE slot B
132516
CISCO
10000
PERFORMANCE ROUTING ENGINE
FAIL
STAT U S
ACO
CRITICAL
MINOR
MAJOR
CONSOLE
ETHERNET
LINK
ACTIVITY
AUX
SLOT 0
SLOT 1
CISCO
10000
PERFORMANCE ROUTING ENGINE
FAIL
STATUS
ACO
CRITICAL
MINOR
MAJOR
CONSOLE
ETHERNET
LINK
ACTIVITY
AUX
SLOT 0
SLOT 1
CISCO
10000
ENABLE
ALARM
LOOP
FAIL
OC-12/STM-4 ATM SM-IR
CARRIER
TX
RX
CISCO
10000
CARRIER
ALARM
LOOP
FAIL
6XCT3–DS0
0
1
2
3
4
5
CISCO
10000
CARRIER
ALARM
LOOP
FAIL
6XCT3–DS0
0
1
2
3
4
5
CISCO
10000
CARRIER
TX
RX
FAIL
OC-12/STM-4 POS SM-IR
CISCO
10000
CARRIER
TX
RX
FAIL
OC-12/STM-4 POS SM-IR
3
1
2