Installation guide

1-6
Cisco 10000 Series Routers Line Card Hardware Installation Guide
OL-6773-04
Chapter 1 4-Port OC-3/STM-1 ATM Line Card Overview
Cables and Connectors
Figure 1-3 Line Card Slot Designations for the Cisco 10005 Router
The 4-port OC-3/STM-1 ATM line card can be installed in line card slot 1 through slot 5.
Cables and Connectors
Table 1-5 provides optical cable specifications for the line card.
Go to Chapter 16, “Preparing for Installation” to begin the installation or replacement of the line card.
For troubleshooting information, see Chapter 18, “Troubleshooting the Installation.”
1 PRE slot A 3 Line card slots 1 (top) to 5 (bottom)
2 PRE slot B
132516
CISCO
10000
PERFORMANCE ROUTING ENGINE
FAIL
STATUS
ACO
CRITICAL
MINOR
MAJOR
CONSOLE
ETHERNET
LINK
ACTIVITY
AUX
SLOT 0
SLOT 1
CISCO
10000
PERFORMANCE ROUTING ENGINE
FAIL
STATUS
ACO
CRITICAL
MINOR
MAJOR
CONSOLE
ETHERNET
LINK
ACTIVITY
AUX
SLOT 0
SLOT 1
CISCO
10000
ENABLE
ALARM
LOOP
FAIL
OC-12/STM-4 ATM SM-IR
CARRIER
TX
RX
CISCO
10000
CARRIER
ALARM
LOOP
FAIL
6XCT3–DS0
0
1
2
3
4
5
CISCO
10000
CARRIER
ALARM
LOOP
FAIL
6XCT3–DS0
0
1
2
3
4
5
CISCO
10000
CARRIER
TX
RX
FAIL
OC-12/STM-4 POS SM-IR
CISCO
10000
CARRIER
TX
RX
FAIL
OC-12/STM-4 POS SM-IR
3
1
2
Table 1-5 Optical Specifications
Transceiver Type Transmit Power
Maximum
Power to
Receiver
Minimum
Receiver
Sensitivity
Nominal Distance
Between Stations Wavelength
Fiber Type:
Single Mode
Single-mode
intermediate reach
–15 dBm minimum to
–8 dBm maximum
–8 dBm –28 dBm Up to 9 mi (15 km) 1280 nm to
1335 nm
Core size 8 to 10
microns
Single-mode long
reach (LR)
–5 dBm minimum to
0 dBm maximum
–10 dBm
1
1. For LR, a minimum of 10 dB of total attenuation between transmitter and receiver is required. Exceeding the maximum
receive power can damage the optics.
–34 dBm Up to 25 mi (40 km) 1280 nm to
1335 nm
Core size 8 to 10
microns