Installation guide

18-19
Cisco 10000 Series Routers Line Card Hardware Installation Guide
OL-6773-04
Chapter 18 Troubleshooting the Installation
Fast Ethernet and Gigabit Ethernet Line Card Troubleshooting Information
An SFP module with
the same serial
number as another
SFP module is
inserted. Both are
Cisco-supported
Gigabit Ethernet
SFP modules.
The FAIL LED is
blinking on the line card
in which the second SFP
module was inserted.
%C10KGE1H-6-SFP_OK: Interface GigabitEthernet1/0/0, 1000BASE-SX
Gigabit ethernet module (SFP) inserted
%C10KGE1H-3-SFP_SPURIOUS: Interface GigabitEthernet1/1/0, Gigabit
ethernet module (SFP) is a duplicate spurious
%C10K_ALARM-6-INFO: ASSERT CRITICAL GigE1H 1/1/0 C10K
Gigabit Ethernet SFP module spurious
An SFP module
hardware problem
occurs.
The FAIL LED will
blink when there is a TX
fault as long as the
invalid SFP module
causing the error
situation is present.
%C10K-3-LC_ERR: Slot[8/1] Line-card Port 0: GBIC HW TX Fault
Table 18-4 SFPs and Cisco IOS Console Messages (continued)
Situation Response/Description Console Message