Installation guide

17-43
Cisco 10000 Series Routers Line Card Hardware Installation Guide
OL-6773-04
Chapter 17 Installing and Removing Line Cards
Removing an SFP Module or GBIC Module
Removing an SFP Module or GBIC Module
Use the following procedure to remove an SFP module or GBIC module from a line card.
Note You can remove an SFP module or GBIC module while the system is powered on, but the interface shuts
down.
Step 1 Attach an antistatic wrist strap to your wrist and to an ESD socket on the chassis, or to a bare metal
surface on the chassis or frame (Figure 17-42).
Figure 17-42 ESD Chassis Connection
1 ESD socket
PROCESSOR ONLY
POWER
FAULT
MISWIRE
CISCO
10000
PERFORMANCE ROUTING ENGINE
SLOT 0
STATUS
FAIL
BITS
P/N
ESR-PRE3
PERFORMANCE ROUTING ENGINE
SLOT 0
STATUS
FAIL
BITS
P/N
ESR-PRE3
CH OC-12-DSO SM-IR
6XCT3–DS0
5
6XCT3–DS0
5
FAIL
6XCT3–DS0
5
6XCT3–DS0
5
6XCT3–DS0
5
OC–12/STM–4 POS SM–IR
126144
1