Installation guide

17-36
Cisco 10000 Series Routers Line Card Hardware Installation Guide
OL-6773-04
Chapter 17 Installing and Removing Line Cards
Attaching Cables
Figure 17-34 Attaching Ethernet Cables
Step 2
Go to the “Checking the Installation” section on page 17-58.
Attaching the 24-Port Channelized E1/T1 Line Card Adapter Cable
An RJ-45 STP cable with two male RJ-45 connectors is required to connect the adapter cable and
RJ-45 ports on the face of the line card (Figure 17-35).
Figure 17-35 75–120 Ohm Adapter Cable
Cisco cable adapters (CAB-ADAPT-75-120) connect 75-ohm unbalanced G.703 E1 coaxial BNC
transmit and receive lines to Cisco E1 120-ohm balanced transmit and receive lines
1
Link
Act
0
Link
Act
132279
45561
DISCONNECT XMIT SHIELD TO GND 1 2
CONNECT XMIT SHIELD TO GND 1 2
1 2
DISCONNECT XMIT SHIELD TO GND 1 2
CONNECT XMIT SHIELD TO GND 1 2
12
X
MIT
RJ-48c
RCV