Installation guide

17-8
Cisco 10000 Series Routers Line Card Hardware Installation Guide
OL-6773-04
Chapter 17 Installing and Removing Line Cards
Removing and Installing Line Cards
Removing the Cisco 10008 Front Cover
Use the following procedure to remove the front cover from the Cisco 10008 router (Figure 17-6 and
Figure 17-7).
• If your Cisco 10008 router does not have a front bezel, go to the “Installing Full-Size Line Cards”
section on page 17-10, the “Installing Half-Height Line Cards” section on page 17-16, the
“Removing Full-Size Line Cards” section on page 17-46, or the “Removing Half-Height Line Cards
and Carrier” section on page 17-51.
• If your Cisco 10008 router has a bezel with bezel plugs, go to step 1.
• If your Cisco 10008 router has a bezel without bezel plugs, go to step 2.
Figure 17-6 Inserting a Screwdriver Blade into a Bezel Latch
Figure 17-7 Unlocking the Bezel Latch
Step 1 Unlock each bezel latch by inserting the tip of a flat-blade screwdriver between the top and bottom
sections of the latch (see Figure 17-6), and then rotating the screwdriver to unlock the top portion of the
latch (see Figure 17-7).
Repeat this procedure for all four bezel latches and then remove the latches (Figure 17-8).
30038
POWER
FAULT
MISWIRE
POWER
FAULT
MISWIRE
FANS OK
FAN FAILURE
MULTI-FAN FAILURE
POWER
FAULT
MISWIRE
Cisco 10000
30039
POWER
FAULT
MISWIRE
POWER
FAULT
MISWIRE
FANS OK
FAN FAILURE
MULTI-FAN FAILURE
POWER
FAULT
MISWIRE
Cisco 10000