Installation guide

ManualsBrandsCisco ManualsComputer equipmentBlower Module 10000 ESR

161

162

163

164

165

166

167

168

169

170

17-7

Cisco 10000 Series Routers Line Card Hardware Installation Guide

OL-6773-04

Chapter 17 Installing and Removing Line Cards

Removing and Installing Line Cards

Figure 17-5 BNC Connectors on the Rear of the Cisco 10005 Router

Also see Appendix A, “Cisco 10005 Extender Card Information” for information about the extender card

which must be used with the 8-port unchannelized E3/T3 line card in the Cisco 10005 chassis.

All Cisco 10005 line cards connect to a backplane in the center of the chassis, and require extender cards

to deliver the alarm, BITS clock, and DS3 signals to the rear of the chassis to make them accessible. The

Cisco 10005 alarm extender card and T3/E3 extender card extend and terminate these signals.

Removing and Installing Line Cards

Some early Cisco 10008 chassis were shipped with front covers. The Cisco 10005 chassis has no front

cover.

• If your Cisco 10008 chassis has no front cover, or if you have a Cisco 10005 router, go to one of the

following sections:

–

Installing Full-Size Line Cards, page 17-10

–

Installing Half-Height Line Cards, page 17-16

–

Removing Full-Size Line Cards, page 17-46

–

Removing Half-Height Line Cards and Carrier, page 17-51

• If your Cisco 10008 chassis has a front cover, go to the “Removing the Cisco 10008 Front Cover”

section on page 17-8.

1 Line card slots 1 (top) to 5 (bottom) 3 Subslots 1/0 (top) to 5/0 (bottom)

2 Subslots 1/1 (top) to 5/1 (bottom)

132319

THIS UNIT HAS MORE THAN ONE POWER

SUPPLY CORD. DISCONNECT TWO (2)

POWER SUPPLY CORDS BEFORE

SERVICING TO AVOID ELECTRIC SHOCK.

CAUTION

POWER

FAULT

100-240V

50/60 HZ

15-7A

THIS UNIT HAS MORE THAN ONE POWER

SUPPLY CORD. DISCONNECT TWO (2)

POWER SUPPLY CORDS BEFORE

SERVICING TO AVOID ELECTRIC SHOCK.

CAUTION

POWER

FAULT

100-240V

50/60 HZ

15-7A

CRITICAL

ALARM

MINOR

ALARM

MAJOR

ALARM

60 VDC

1A MAX

A+

A-

B+

B-

EXT

CLOCK