Installation guide

11-3
Cisco 10000 Series Router Line Card Hardware Installation Guide
OL-6773-04
Chapter 11 1-Port Gigabit Ethernet Line Card Overview
LEDs
LEDs
The 1-port Gigabit Ethernet line card LEDs are shown in Figure 11-1.
Figure 11-1 1-Port Gigabit Ethernet Line Card Faceplate Description
Table 11-3 provides a description of the 1-port Gigabit Ethernet line card LEDs.
1 FAIL LED 4 RX LED
2 RX (receive) 5 TX LED
3 TX (transmit) 6 LINK LED
1
32585
CISCO
10000
LINK
TX
RX
FAIL
GIGABIT ETHERNET
1 2 3
4
5
6
Table 11-3 LEDs Description
LED Label Color State Meaning
FAIL Yellow Off Off when line card is working properly. Turns on for a
few seconds during line card power-on self test (POST),
then turns off when the line card is working properly.
Blinking Blinks when the GBIC is bad.
On On when the line card POST fails.
RX (receive) Green On The port is receiving traffic.
Off The port is not receiving traffic.
TX (transmit) Green On The port is transmitting traffic.
Off The port is not transmitting traffic.
LINK Green On On when the link is up.
Off Off when the link is down.